- Year: 1998
- Make: BMW
- Model: K1200RS
- Trims Available: 0
- Made In: GERMANY
- Body & Doors: Not on File
- Engine: 1171CC
- Transmission: Not on File
- Driveline: Not on File
- Seating: Not on File
- MSRP: $Not on File
- MPG: Not on File
- Tires: Not on File
- Tank Size: Not on File
1998 BMW K1200RS Review
Vehicle Overview
It is manufactured in Germany. The car has 0 variation available for its customers. The engine type is 1171CC. 1998 BMW K1200RS has had 4 recalls in the past 26 years.
Popular VINs
- WB10554A3WZA50218
Popular VINs
- WB10554A3WZA50218
Vehicle Specifications
Safety & Recalls
Recall 6720 started on 09/12/2000 by MFR effecting 2,368 units.
-
Summary: VEHICLE DESCRIPTION: MOTORCYCLES. A SPRING-LOADED THERMOSTATIC ELEMENT IN THE OIL THERMOSTAT HOUSING IS HELD IN PLACE BY A COVER THAT IS RETAINED BY A SNAP RING. THE SNAP RING MAY NOT HAVE BEEN PROPERLY INSTALLED DURING PRODUCTION. DURING VEHICLE OPERATION, THE SNAP RING COULD UNSEAT, ALLOWING THE COVER TO LOOSEN OR DETACH, RESULTING IN LOSS OF THE ENTIRE OIL VOLUME.
-
Consequence: ENGINE DAMAGE COULD OCCUR IF THE ENGINE IS NOT IMMEDIATELY SWITCHED OFF. IN ADDITION, OIL COULD TRAVEL ALONG THE ENGINE COVER AND ULTIMATELY CONTACT THE REAR TIRE, REDUCING ITS TRACTION AND AFFECTING THE STABILITY OF THE MOTORCYCLE, POSSIBLY RESULTING IN A CRASH AND PERSONAL INJURY.
-
Remedy: DEALERS WILL INSPECT THE SNAP RING INSTALLATION AND IF THE SNAP RING IS NOT FULLY SEATED, THE COMPLETE OIL PUMP INTERMEDIATE FLANGE WILL BE REPLACED.
-
Notes: OWNER NOTIFICATION BEGAN OCTOBER 13, 2000. OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT BMW AT 1-800-831-1117, OPTION #5. ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).
Recall 6722 started on 09/12/2000 by MFR effecting 188 units.
-
Summary: VEHICLE DESCRIPTION: MOTORCYCLES. THE CYLINDER HEAD CONTAINS TWO SEALING PLUGS COVERING HOLES IN THE AREA NEAR THE SPARK PLUGS. ONE OR BOTH PLUGS MAY NOT HAVE BEEN FULLY SEATED DURING VEHICLE ASSEMBLY. EITHER OR BOTH OF THE SEALING PLUGS COULD LOOSEN OR COMPLETELY DETACH FROM THEIR MOUNTING POINT DURING VEHICLE OPERATION.
-
Consequence: THIS CONDITION COULD ALLOW COOLANT TO ESCAPE, TRAVEL ALONG THE ENGINE COVER, AND CONTACT THE REAR TIRE, REDUCING ITS TRACTION AND AFFECTING THE STABILITY OF THE MOTORCYCLE. IN ADDITION, THE LOSS OF COOLANT COULD LEAD TO INCREASED ENGINE OPERATING TEMPERATURE AND POSSIBLE OVERHEATING.
-
Remedy: DEALERS WILL REPLACE THE SEALING PLUGS WITH A STAINLESS STEEL PLUG DESIGN.
-
Notes: OWNER NOTIFICATION BEGAN OCTOBER 12, 2000.OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT BMW AT 1-800-831-1117, OPTION #5. ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).
Recall 13163 started on 10/14/1998 by ODI effecting 1,000 units.
-
Summary: VEHICLE DESCRIPTION: MOTORCYCLES. DURING EXTENDED OPERATION IN HIGH AMBIENT TEMPERATURE CONDITIONS, THE AREA OF THE PUMP MOUNTING SURFACE OF THE FUEL TANK CAN DEFORM, FORMING A GAP BETWEEN THE TANK MOUNTING SURFACE AND THE GASKET, ALLOWING FUEL TO ESCAPE FROM THE TANK AT THAT AREA.
-
Consequence: IF AN IGNITION SOURCE WAS PRESENT, A FIRE COULD OCCUR RESULTING IN PERSONAL INJURY.
-
Remedy: DEALERS WILL REPLACE THE FUEL PUMP-TO-TANK GASKET.
-
Notes: OWNER NOTIFICATION IS EXPECTED TO BEGIN BY THE END OF DECEMBER 1998.OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT BMW AT 1-800-831-1117.ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-888-DASH-2-DOT (1-888-327-4236).
Recall 14203 started on 08/08/1997 by MFR effecting 973 units.
-
Summary: VEHICLE DESCRIPTION: MOTORCYCLES. THE ADJUSTING SCREW FOR THE PRESSURE POINT OF EITHER THE BRAKE OR CLUTCH LEVERS MAY NOT BE SUFFICIENTLY TIGHT, DUE TO GREASE CONTAMINATION OF THE THREADS.
-
Consequence: THE SCREW(S) CAN BACK OUT OVER TIME WHILE THE VEHICLE IS BEING OPERATED CAUSING A CHANGE IN THE PRESSURE POINT OF THE MASTER CYLINDER FOR THE CLUTCH AND/OR FRONT BRAKE INCREASING THE RISK OF A VEHICLE CRASH.
-
Remedy: DEALERS WILL CHECK THE ADJUSTMENT SCREWS OF THE FRONT BRAKE AND CLUTCH LEVERS FOR MOVEMENT. IF THE SCREWS ARE TIGHT, NO FURTHER ACTION WILL BE TAKEN. IF A SCREW IS FOUND TO BE LOOSE, IT WILL BE REMOVED, CLEANED AND REINSTALLED WITH NEW LOCTITE.
-
Notes: OWNER NOTIFICATION BEGAN AUGUST 11, 1997.OWNERS WHO TAKE THEIR VEHICLES TO AN AUTHORIZED DEALER ON AN AGREED UPON SERVICE DATE AND DO NOT RECEIVE THE FREE REMEDY WITHIN A REASONABLE TIME SHOULD CONTACT BMW AT 1-800-831-1117, OPTION #5.ALSO CONTACT THE NATIONAL HIGHWAY TRAFFIC SAFETY ADMINISTRATION'S AUTO SAFETY HOTLINE AT 1-800-424-9393.
Find a car by a VIN code
Recent 1998 BMW K1200RS VIN Searches
- WB10554A3WZA50218